My Homepage

11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

You may be surprised to see just the way to spray car paint really can not be difficult. That doesn't mean that you can just grab a tin of paint and go at it. There are some basics you have to know. Both in the preparation and application.

Step A:

Prepare by gathering all of your things that you're going to need.

Measure B:

You'll have to examine the car carefully. These will have to be sanded with 300 grit sand paper. It also enables the spray car paint to adhere better. Make sure all the dust dirt and debris are taken from the vehicle, after you have finished sanding. It is imperative the auto be totally clean.

Measure C:

This will make sure you get an overall even layer of your colored paint plus helps the paint to stick nicely. Be sure you allow for drying in between and apply light coats when you spray the primer. The way to spray auto paint takes a little getting used to.

Step D:

Now you're pretty well to the point at which you might be around ready to spray on the shade. Before you begin with the car either way, make several practice strokes on an object. Once you might be ready, start the passes with the paint without reluctance. You will end up getting uneven coverage if you hold the spray can or gun in one place and maybe the paint will run. Should this happen you have a major repair job on your had. You will most probably have instructions as to the best way to spray on car paint using the equipment or spray cans.

Step E:

You may want to research this alternative on the web, or check with someone that is comfortable with just how to spray auto paint

Step F:

You're down to the finishing touches once you happen to be thoroughly satisfied with the shade. You may now need to apply several coatings that are clear. This will give the shine and finished appearance to the auto in addition to protect the finish. It will be up to you personally although probably two layers Alloy Wheel Repair Enfield will be sufficient. Make absolutely certain it truly is dry in between coats.

Step G:

Once more, you've the alternative of wet sanding if you prefer. Again, I recommend you request the advice of individuals which are comfortable with how to spray paint a car. You need with the following grits in this arrangement if you determine to follow this measure then. This will remove spots which will be too heavy in the clear coat application.

Step H:

Now you'll need to using a rubbing compound in order to use a 2000 grit to remove any scratches to buff the surface.

Step I:

You should buff the surface. To try this just use a moderate cut polish.



Step J:

As a final touch, you may want to apply a couple of coats of wax.

This website was created for free with Own-Free-Website.com. Would you also like to have your own website?
Sign up for free